This repository contains necessary codes to reproduce the experimental results reported in the paper Neural Networks with Few Multiplications. It is forked from Matthieu Courbariaux's BinaryConnect repo.

The 3 differnt branches in this repo corresponds to 3 different network configurations. They are:

• binary: Implements binary connect with quantized backprop.
• ternary: Implements ternary connect with quantized backprop.
• fullresolution: A control group training with ordinary backprop and no weight binarization.

You can use

git checkout <branch name>

to switch between them.

All the three branches provide scripts for MNIST, CIFAR-10, and SVHN datasets. To run those scripts, you can use the same command no matter which branch you are in. Execute the following commands for different datasets:

python mnist.py

This python script trains an MLP on MNIST. It should run for less than 1 hour on a Tesla M2050 GPU. The final test error should be around 1.33% (fullresolution branch), 1.29% (binary branch), and 1.15% (ternarybranch).

python cifar10.py

This python script trains a CNN on CIFAR-10. It should run for about 5 hours on a Titan X GPU. The final test error should be around 15.64% (fullresolution), 12.08% (binary), and 12.01% (ternary).

export SVHN_LOCAL_PATH=/tmp/SVHN/
python svhn_preprocessing.py

This python script (taken from Pylearn2) computes a preprocessed version of the SVHN dataset in a temporary folder.

python svhn.py

This python script trains a CNN on SVHN. It should run for about 15 hours on a Titan X GPU. The final test error should be around 2.85% (fullresolution), 2.48% (binary), and 2.42% (ternary).

• Python, Numpy, Scipy
• Theano 0.6 or later
• Pylearn2 0.1
• PyTables (only for the SVHN dataset)
• a fast GPU or a large amount of patience

The python scripts mnist.py, cifar10.py and svhn.py contain all the relevant hyperparameters. It is very straightforward to modify them. layer.py contains the binarization function (binarize_weights) and quantized backprop function (quantized_bprop).

To conveniently disable quantized backprop alone, go to the model.py file, comment out line 112 and uncomment line 114.

To monitor the representation at each layer, uncomment line 293~339. You should be able to see an animated figure showing histograms about each layer's distribution.

Have fun!