./start_dev.sh # This will cause docker to start your working environment; this should take roughly 1-3 minutes depending on your network speed
# Once you are inside the container, your console will look akin to "root@ec5410d0a265:/usr/src#"
./build.sh # This will run make and build the fiurmware. If you have weird build errors try running clean.sh or rm -rf'ing the out folder first
# You may need to take the buds out of the case, wait three seconds, then place them back.
# This wakes them up and the programmer needs to catch this reboot.
# You'll know it worked when you see the lights on the case flash.
# You can run the following to program each bud.
# Flashing both of them is not necessary.
# In my experience, ttyACM1 is the right earbud, while ttyACM0 is the left one, YMMV.
bestool write-image out/open_source/open_source.bin --port /dev/ttyACM0
bestool write-image out/open_source/open_source.bin --port /dev/ttyACM1