Board Support Crate for the BetaFPV F3 Drone Flight Controller

• LED control
• Motor control
• Serial communication
• Basic gyro/accelerometer functionality
• A script to build each example and flash it onto the controller

• Sensor fusion
• Radio receiver
• USB port support

To build the led-control example and flash it onto a BetaFPV F3 board, first plug the board into your computer while holding down the BOOT button to enable bootloader mode, then run the following command:

    ./flash-example led-control

Licensed under either of

• Apache License, Version 2.0, (LICENSE-APACHE or https://www.apache.org/licenses/LICENSE-2.0)
• MIT license (LICENSE-MIT or https://opensource.org/licenses/MIT)

at your option.

Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.