You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This crate aims at providing a gcode parser to the rusty printer project (and other if it can fit).
The minimal footprint is achieved with all features disabled and is in the order of ~80B of
RAM and around 2kB of Flash memory. The typical set of features
["parse-trailing-comment", "parse-checksum", "optional-value"] has a footprint of around 4kB
of flash memory for around 80B of RAM.
Finally with all features, the memory footprint reaches around 7kB in flash and around 170B
in RAM.
Features
std : Enabled by default
parse-comments : enables the parser to return GCode::Comment(String); requires an allocator.
parse-trailing-comment: allows line to end with a ; comment.
parse-checksum : Enables the use of xorsum.
parse-parameters : Enables the use of # parameters ; requires an allocator.
If string-value is enabled then parameters may use string index.
If optional-value is enabled then parameters value may be omitted but NOT the indices.
parse-expressions : Enables parsing infix expressions ; requires an allocator.
optional-value : Allows to omit in RealValue in word and parameter value positions.
Parameter indices cannot be omitted nor can be literals in expressions.
string-value : Allows RealValue to be a string. Any character preceded with \ will be
used as is (useful for ", ) or new line).